A turbopump is a pump powered by its own gas turbine inside a rocket

A turbopump is a pump powered by its own gas turbine inside a rocket
Image: Intellect (generated)

In short: A rocket engine must force enormous quantities of liquid fuel and oxidizer into its combustion chamber. A turbopump does this using a gas turbine on the same shaft as the pump, spinning at tens of thousands of revolutions per minute. Engineers adopted this design in the 1930s and 1940s because it scales far better than the alternative for large rockets.

A turbopump is an assembly that joins a liquid pump to a gas turbine through a shaft, sometimes with gears. Its main job is to raise the pressure of liquid propellants so they can be fed into a rocket engine's combustion chamber. Turbopumps were first developed in the United States and Germany in the 1930s and 1940s. Although they are far more complicated than simple pressure-fed systems, they scale much better in large rockets, because pressure-fed tanks would need to become increasingly thick and heavy to supply high chamber pressures.

The pumping work is done by impellers, which spin at thousands of revolutions per minute and accelerate the liquid. The goal is pressure rather than speed, so each impeller is surrounded by a volute or diffuser, a specially shaped housing that slows the flow and raises its pressure. Most turbopumps use centrifugal pumps, which give high pressure but modest flow, while rarer axial-flow pumps give high flow but need many stages. Upstream, an inducer gently raises the pressure of incoming fluid so it does not cavitate before reaching the impeller.

The turbine is driven by hot gas, and the way that gas is produced defines each rocket engine cycle. Jet engines can route their turbine downstream of the combustion chamber, but rockets cannot, because their mixtures burn so hot that nearly every material would melt. Designers therefore use workarounds, such as a separate gas generator or preburner that runs far from the ideal mixture, or an expander cycle in which fuel is heated in the engine's cooling passages until it becomes gas. Turbopump bearings face a further problem: ordinary lubricants freeze at the cryogenic temperatures of the propellants, so bearings run bare and are cooled by a small flow of cold propellant.

Keeping fuel and oxidizer apart is essential, because a leak inside the turbopump could start a fire that destroys the engine. Engineers use labyrinth seals, face seals and carbon ring seals, and they supply an inert purge gas, often helium, at higher pressure than the propellants to block leaks in the most critical joint. The rotor must also avoid running near critical speeds, where vibration called whirling can build up and cause failure. Together, these demands make turbopump design one of the most precise tasks in rocket engineering.

Opens the Intellect+ feed with this card first. Swipe up for the next one.

Sources

To cite this card, link to https://intellectplus.co.uk/app/space-turbopump.

How we source, check and correct cards: Editorial standards.

General information, not professional advice. Spotted an error? Flag the card or see corrections and complaints.

Intellect Plus is a visual educational discovery platform for exploring fascinating facts and ideas. Brain Food, Not Brain Rot. What is Intellect Plus?

Related

Finding something worth knowing…